Assets with Reboot and Reboot Delay

Assets with Reboot

For each asset on your System, that you add to the System Builder, you can check the Reboot system after installation? checkbox. This tells CONS3RT to reboot the host after the asset has completed installation. This is useful when installing an application that requires reboot after installation.

Additionally, you can set a Reboot Delay on each reboot as described below. In most cases, set the Reboot Delay to 0 minutes.

Reboot Delay

Reboot delay is an optional setting when adding assets in the System Builder. On each asset you can check the Reboot system after installation? checkbox, and the following with pop up:

Reboot Delay

The Reboot Delay setting is used to set the amount of time CONS3RT will wait after coming back from the reboot. This is useful in following install of assets that:

  • Performs Windows SysPrep (recommend using 8-10 minutes reboot delay)
  • Changes the Windows SysID (recommend using 8-10 minutes reboot delay)
  • Any asset that requires additional configuration time after coming up from reboot

In most cases, start with setting the Reboot Delay to 0 minutes, and increase it if you run into an issue.